W3G800NS2671

W3G800-NS26-71

EC axial fan - AxiCool

Motor: M3G150-FF

Technical description
Weight 39.2 kg
Motor size 150
Size 800 mm
Rotor surface Painted black
Electronics housing material Die-cast aluminum, painted black
Blade material PP plastic
Fan housing material PP plastic
Material guide vanes PP plastic
Guard grille material Steel, coated with black plastic (RAL 9005)
Number of blades 5
Airflow direction V
Direction of rotation Clockwise, viewed toward rotor
Degree of protection IP55
Insulation class "F"
Ambient temperature note If there is a risk of ice formation, the fan is only to be operated with a heating tape in the fan housing. Further information can be obtained from ebm-papst. As fan only suitable for use with industrial evaporators
Moisture (F) / Environmental (H) protection class H2
Max. permitted ambient temp. for motor (transport/storage) +70 °C
Min. permitted ambient temp. for motor (transport/storage) -40 °C
Installation position See fitting instructions
Condensation drainage holes On rotor side
Mode S1
Motor bearing Ball bearing with low-temperature lubricant
Technical features - Output 10 VDC, max. 10 mA - Operation and alarm display - External 24 V input (parameter setting) - External release input - Alarm relay - Integrated PID controller - Motor current limitation - PFC, passive - RS-485 MODBUS-RTU - Soft start - Control input 0-10 VDC / PWM - Control interface with SELV potential safely disconnected from the mains - Thermal overload protection for electronics/motor - Line undervoltage / phase failure detection
EMC immunity to interference According to EN 61000-6-2 (industrial environment)
EMC interference emission According to EN 61000-6-3 (household environment), except EN 61000-3-2 for professionally used equipment with a total rated power greater than 1 kW
Touch current according to IEC 60990 (measuring circuit Fig. 4, TN system) <= 3,5 mA
Electrical hookup Terminal box with cable
Motor protection Reverse polarity and locked-rotor protection
Protection class I (with customer connection of protective earth)
Conformity with standards EN 61800-5-1 / CE
Approval EAC