| Weight |
20 kg |
| Motor size |
112 |
| Size |
630 mm |
| Rotor surface |
Painted black |
| Electronics housing material |
Die-cast aluminum, painted black |
| Blade material |
Press-fitted sheet steel blank, sprayed with PP plastic |
| Fan housing material |
PP plastic |
| Material guide vanes |
PP plastic |
| Guard grille material |
Steel, coated with black plastic (RAL 9005) |
| Number of blades |
5 |
| Airflow direction |
V |
| Direction of rotation |
Counterclockwise, viewed toward rotor |
| Degree of protection |
IP55 |
| Insulation class |
"F" |
| Ambient temperature note |
If there is a risk of ice formation, the fan is only to be operated with a heating tape in the fan housing. Further information can be obtained from ebm-papst. As fan only suitable for use with industrial evaporators |
| Moisture (F) / Environmental (H) protection class |
H2 |
| Max. permitted ambient temp. for motor (transport/storage) |
+70 °C |
| Min. permitted ambient temp. for motor (transport/storage) |
-40 °C |
| Installation position |
See fitting instructions |
| Condensation drainage holes |
On rotor side |
| Mode |
S1 |
| Motor bearing |
Ball bearing with low-temperature lubricant |
| Technical features |
- Output 10 VDC, max. 10 mA
- Operation and alarm display
- Alarm relay
- Integrated PID controller
- Power limiter
- Motor current limitation
- PFC, active
- RS-485 MODBUS-RTU
- Soft start
- Control input 0-10 VDC / PWM
- Control interface with SELV potential safely disconnected from the mains
- Thermal overload protection for electronics/motor
- Line undervoltage / phase failure detection |
| EMC immunity to interference |
According to EN 61000-6-2 (industrial environment) |
| EMC circuit feedback |
According to EN 61000-3-2/3 |
| EMC interference emission |
According to EN 61000-6-3 (household environment) |
| Touch current according to IEC 60990 (measuring circuit Fig. 4, TN system) |
<= 3,5 mA |
| Motor protection |
Thermal overload protector (TOP) internally connected |
| Protection class |
I (with customer connection of protective earth) |
| Conformity with standards |
EN 61800-5-1 / CE |
| Approval |
CSA C22.2 No. 77 + CAN/CSA-E60730-1 / UL 1004-7 + 60730-1 / EAC |
